Whirlpool F1E1: Control Module Reset

Meaning: Whirlpool lists the potential cause as the control module.
This page publishes a power cut and nothing else. Drain, fill, and leak checks are different Whirlpool codes.
Whirlpool's F1E1 page names the control module and stops. There is no filter to wash and no hose to straighten. A 30 second power cut is the published check. If the code comes back, schedule service and leave the control closed.
Count a flashing Clean light before you decide this is the code. The first burst is F and the second burst is E, with about 1 to 2 seconds between them and about 5 seconds before the pattern repeats. One flash and one flash is F1E1. Whirlpool's reading guide uses seven flashes then one flash only as a counting example. It never says what F7E1 means, so that code is not on this site. Seven flashes then two flashes is F7E2, the wash motor code on the hub.
If the display is a code with an owner check, open that page instead: F9E1 for a long drain, F9E2 for the drain motor code, H2O when water is not detected, F8E4 for the drip tray, and F8E2 for the inlet connection.
Checks Whirlpool publishes
- Unplug the dishwasher for 30 seconds, or switch its breaker off for 30 seconds, then restore power.
- On a digital display, Whirlpool says the code shows as an F and E pair. On a flashing Clean light, count the first burst as F and the second burst as E. A short pause of about 1 to 2 seconds sits between the bursts, and a longer pause of about 5 seconds sits before the pattern repeats. One flash, a pause, and one flash is F1E1.
When to call a technician
If F1E1 returns, Whirlpool says to schedule service. Do not open the control.
Frequently asked questions
What does Whirlpool dishwasher F1E1 mean?
Whirlpool lists the potential cause as the control module. This page publishes a power cut and nothing else. Drain, fill, and leak checks are different Whirlpool codes.
What does Whirlpool say to check for F1E1?
Unplug the dishwasher for 30 seconds, or switch its breaker off for 30 seconds, then restore power. On a digital display, Whirlpool says the code shows as an F and E pair. On a flashing Clean light, count the first burst as F and the second burst as E. A short pause of about 1 to 2 seconds sits between the bursts, and a longer pause of about 5 seconds sits before the pattern repeats. One flash, a pause, and one flash is F1E1. If water is reaching the floor, shut the supply off. Do not open the control.
When should I call a technician for F1E1?
If F1E1 returns, Whirlpool says to schedule service. Do not open the control.
Sources
Retrieved 20 Nov 2026. Models differ. If your manual defines F1E1 differently, the manual wins. Which Error Code is not affiliated with Whirlpool.
All Whirlpool dishwasher codes · Whirlpool · Dishwasher brands · Safety notes · All error codes